In this article we’re going to examine how to create your own dog mask. We’ll cover the basics and then go on to look at a number of the more advanced tips and techniques which you can use.
For those who have a dog that likes to bark, and particularly if http://novohealth.intnex.hk/the-best-cheap-dog-food-finding-the-right-type-of-inexpensive-dog-food/ your dog loves to play in the backyard and other areas of the house, you will need to get them some particular dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the first part of the setup that will look a little scary at first, but it’s really very straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can’t just cut a rectangular shape out of the cardboard, so you will have to cut around the edge of the mask so you get something that resembles a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.
Then you will need to wrap the cardboard around the edges of the paper plate, making certain there is a good seal between the two pieces so you can ensure that nothing will leak when you put the mask on. Make sure that the edges are cut so that the edges aren’t sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the entire mask. You’ll want to start with one side of the mask , so you can work your way round it before moving onto the other side. The paint has to be slightly thicker than the cardboard, and it’s best that you leave about one-third of an inch of paint on the edges so that it runs across the cardboard.
Don’t worry too much about the paint getting stuck into your mask. It’s easy to eliminate it later, and it will leave you with a nice finished mask to show off to everyone! It’s also a good idea to wipe away any excess paint after you are done, so that you don’t wind up with smudges or smears on your dog.
Then it is time to glue the mask onto your dog’s head. First you need to be certain that you have a secure fit between the mask and your dog’s head. As soon as you’ve made sure that it’s secure, then you may begin to glue the mask on the dog’s face. Take the piece of cardboard that’s used for the base of the mask and fold it over. Make certain it’s quite strong and then use your hands to ensure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you have the mask snugged firmly onto the surface of your dog. Do not make the folds too large or else it could look messy. Once you’ve completed this, you can then take out the mask and attach the cardboard ears. And attach the other area of the mask onto the dog. Be sure the ears are flat and make certain it is not too short or long as this will cause some problems with the mask slipping off the dog’s face.
If you’re using a dog mask because your dog protection, you’ll have to do some sanding to be certain it’s safe on your dog. You can do it by sanding off any excess paper which might have been eliminated from your mask.